|
Avoiding
Carpel Tunnel Syndrome
Carpal tunnel syndrome (CTS) is a painful, debilitating
condition. It involves the median nerve and the flexor tendons
that extend from the forearm into the hand through a "tunnel"
made up of the wrist bones, or carpals, and the transverse
carpal ligament.As you move your hand and fingers, the flexor
tendons rub against the sides of the tunnel. This rubbing can
cause irritation of the tendons, causing them to swell. When
the tendons swell they apply pressure to the median nerve.
The result can be tingling, numbness, and eventually
debilitating pain.
CTS affects workers in many fields. It is common among
draftsmen, meatcutters, secretaries, musicians, assembly-line
workers, computer users, automotive repair workers, and many
others. CTS can be treated with steroids, anti-inflammatories,
physical therapy, or with surgery to loosen the transverse
carpal ligament. Recovery of wrist and hand function is often,
but not always, complete.
CAUSES
Like many skeletomuscular disorders, CTS has a variety of
causes. It is most often the result of a combination of
factors. Among these are:
Genetic predisposition. Certain people are more likely than
others to get CTS. The amount of natural lubrication of the
flexor tendons varies from person to person. The less
lubrication, the more likely is CTS. One study has related
the cross-sectional shape of the wrist, and the associated
geometry of the carpal tunnel, to CTS. Certain tunnel
geometries are more susceptible to tendon irritation.
Health and lifestyle. People with diabetes, gout, and
rheumatoid arthritis are more prone than others to develop
CTS, as are those experiencing the hormonal changes related
to pregnancy, menopause, and the use of birth control pills.
Job stress has also been linked to an increased likelihood of
CTS. And CTS seems to be more frequent among alcoholics.
Repetitive motion. The most common cause of CTS that's been
attributed to the workplace is repetitive motion. When you
flex your hand or fingers the flexor tendons rub against the
walls of the carpal tunnel. If you allow your hand time to
recover, this rubbing is not likely to lead to irritation.
The amount of recovery time you need varies from fractions of
a second to minutes, depending on many circumstances,
including the genetic and health factors mentioned above, as
well as the intensity of the flexing, the weight of any
objects in your hand, and the extent to which you bend your
wrist during flexing.
Trauma. A blow to the wrist or forearm can make the tendons
swell and cause or encourage the onset of CTS.
PREVENTION
Computer keyboard users can take several steps to lower their
chances of developing CTS. Some of these center around the
configuration of the workplace, or "ergonomics." Others have
to do with human factors.
Ergonomics. Proper seating is crucial to good ergonomics. The
height of your seat and the position of your backrest should
be adjustable. The chair should be on wheels so you can move
it easily. Arm rests on the chair, though optional, are often
helpful.
Table height. To adjust the chair properly, look first at the
height of the table or desk surface on which your keyboard
rests. On the average, a height of 27-29 inches above the
floor is recommended. Taller people will prefer slightly
higher tables than do shorter people. If you can adjust your
table, set your waist angle (see below) at 90 degrees, then
adjust your table so that your elbow makes a 90 degree angle
when your hands are on the keyboard.
Wrist angle. If your keyboard is positioned properly your
wrists should be able to rest comfortably on the table in
front of it. Some keyboards are so "thick" that they require
you to bend your hands uncomfortably upward to reach the
keys. If so, it will help to place a raised wrist rest on the
table in front of the keyboard. A keyboard that requires you
to bend your wrists is a common cause of CTS among computer
users.
Elbow angle. With your hands resting comfortably at the
keyboard and your upper arms vertical, measure the angle
between your forearm and your upper arm (the elbow angle). If
it is less than 90 degrees, raise the seat of your chair. If
the angle is greater than 90 degrees, lower the seat. Try to
hold your elbows close to your sides to help minimize "ulnar
displacement" the sideways bending of the wrist (as when
reaching for the "Z" key).
Waist angle. With your elbow angle at 90 degrees, measure the
angle between your upper legs and your spine (the waist
angle). This too should be about 90 degrees. If it is less
than 90 degrees, your chair may be too low (and your knees
too high). Otherwise, you may need to alter the position of
the backrest or adjust your own posture (nothing provides
better support than sitting up straight). (Note: If making
your waist angle 90 degrees changes your elbow angle, you may
need to readjust the height of your chair or table.)
Feet. With your elbows and waist at 90 degree angles, your
feet should rest comfortably flat on the floor. If they don't,
adjust your chair and table height and repeat the steps above.
If your table isn't adjustable and your feet don't comfortably
reach the floor, a raised footrest can help. Otherwise, you
may need a different table.
WORK ROUTINE
You need very little recovery time between keystrokes to cool
and lubricate the flexor tendons. If you type constantly,
however, the need for recovery builds. Further, working with
your hands bent upward at the wrists or frequently bending
your wrists sideways heightens the friction within the carpal
tunnel. It takes longer to recover from these motions. Working
under stress (deadline pressure, anger, or other anxiety) can
make matters even worse.
Many studies recommend a 10-15 minute break each hour to give
yourself the recovery time you need. This needn't be a break
from productive activities just a break from your keyboard.
Exercises can help, too. Try the following:
a) Make tight fists, hold for one second, then stretch your
fingers out wide and hold for five seconds. Repeat several
times.
b) With arms outstretched in front of you, raise and lower
your hands several times. Rotate your hands ten times
(make circles in the air with the fingertips).
Variety is the key. CTS occurs most frequently in workers
whose motions are not only repetitious but are kept up for
hours at a time. If you use a keyboard, structure your
workdays to include a mix of activities each hour. For
example, instead of typing all morning and filing all
afternoon, mix typing and filing throughout the day.
EARLY DETECTION
The most painful cases of CTS are those that have gone
undetected or untreated over a long time. CTS can be caught
easily in its early stages, however, and much of the pain and
all of the disability avoided.
Early symptoms include a tingling in the fingers, often
beginning several hours after work activity has stopped.
Because of this delay in the appearance of symptoms, many CTS
sufferers don't make the connection between their work
activities and the pain they feel until it's too late. The
tingling can lead, over time, to stiffness and numbness in
the fingers and hand, and then to severe wrist and hand pain.
For many individuals the early symptoms of CTS go unnoticed.
Employers and co-workers can help one another identify the
onset of CTS by watching for and pointing out any unconscious
shaking of the hands, rubbing of the wrists, or unusual
postures or hand positions at the keyboard.
At the first sign of CTS, you should be examined by a doctor
who specializes in hand and wrist disorders. The doctor can
perform a number of simple tests to detect CTS, and can
prescribe specific steps for avoiding the problem.
SUMMARY
Carpal tunnel syndrome is common among computer keyboard
users. It can strike anyone, and its consequences are serious.
Awareness of the problem and its causes is crucial to
preventing CTS. With proper ergonomics and attention to the
work routine you can prevent CTS; with early detection and
treatment it need never become debilitating. The employer's
attention to stress levels, proper ergonomics, and the early
warning signs of CTS are important in keeping the ailment at
bay in the workplace.
|
|
|